| Input | Voltage range | 198-264VAC 50Hz /60Hz |
| Rated supply voltage | 220-240VAC 50Hz /60Hz |
| Input Current | 0.3A Max. |
| Power Factor | ≥0.90 @230VAC (100% load) |
| Stand-by Power | ≤0.5W@230V AC (When PUSH is turned off) |
| Efficiency | 88%Max. @230V AC(700MA block, 100% load) |
| Wiring Method | Push terminal, wire cross section:0.75-1.5mm2 |
| Output | Operating mode | Constant current |
| Load type | LED |
| Ripple requirement (Flickering or Flickering-Free) | Flicker value: less than 2% for whole dimming range |
| No-load output voltage | 68VDC Max. |
| Load output voltage range | 6-60VDC |
| Full load output power | 50W Max. |
| Load output current | 350MA(6-60V) 500MA(6-60V) 550MA(6-60V) 650MA(6-58V) 700MA (6-58V) 750MA (6-56V) 850MA(6-56V) 900MA(6-56V) 1050MA(6-49V)12V (0-1050MA) 24V (0-1050MA) |
Constant current/voltage
accuracy | Constant current accuracy ±5% |
| Wiring method | Push terminal, wire cross section:0.75-1.5mm2 |
| Control Method | Primary PUSH dimming | Primary PUSH dimming and secondary PUSH dimming (Max. lead wire length:20m) |
| 1-10V(0-10V)dimming | 1-10V dimming(Port current＜1mA), (Max. lead wire length:20m) |
| Dimming range | Primary PUSH dimming: 1%-100% 1-10V dimming: 1%-100% |
| Potentiometer | Yes, 100kΩ |
| Exception Protection Requirements | Input over voltage protection | 300VAC 2 hours |
| Output over load protection | Yes, auto reset |
| Output no load protection | Yes, auto reset |
Output over temperature
protection | Yes, auto reset |
Output short circuit
protection | Yes, auto reset |
Output hot plug
protection | At least 2 series LED lamp (6V), electrothermal hot plug does not damage the LED lamp |
| Operating Environment | Operating temperature/
humidity | -25℃~50℃, humidity:85% (Non-condensing) |
Storage temperature/
humidity | -40℃~80℃ |
| Max. case temp(Tc) | 85℃ |
| Safety & EMC | Withstand voltage | 3750V AC 5mA 60S (Input “L N”- Output “SEC+ SEC- 1-10V”) 1500V AC 5MA 60S (Input “L N”-“”) 500V AC 5MA 60S (Output “SEC+ SEC- 1-10V”-“Ground”) |
| EMC standard | EN55015 EN61547 EN61000-3-2 EN61000-3-3 |
| Safety standard | EN61347-1 EN61347-2-13 |
| Certification | Semko CE0700 RoHS |
| Others | Degrees of protection | IP20 |
| Type of protection | Class I |
| Installation type | Independent installation |
| Installation dimension | 123*79*23.8mm |
| Memory function | Yes |
| Max. synchronization | 15 units |
| Packaging requirement | PE bag + clapboard + outer carton(K=A) |
| Life | 50000h @Ta 100% load |
